Instruction Manual

Banner Engineering Corp.•Minneapolis,MNU.S.A
www.bannerengineering.com•Tel:763.544.3164
2 P/N 129322 rev. E
SureCross™ DX80K Wireless Configured FlexPower™ Kit
Gateway as
Repeater
I/O
Point
Terminal Block
Label
DX80 Node 1 DX80 Node 2 Terminal Block
Label
I/O
Point
9 DO1 Discrete OUT 1 Discrete IN 1 DI1 1 MINI-BEAM*
10 DO2 Discrete OUT 2 Discrete IN 2 DI2 2
For additional information, including
installation and setup, weatherproofing,
device menu maps, troubleshooting, and
a list of accessories, please refer to the
SureCross™ DX80 Wireless I/O Network
productmanual,Bannerpartnumber132607.
Preconfigured input/output mapping
These are the I/O points as displayed on the device LCD. Any I/O points not shown in the chart are not enabled for this kit.
* Special low-power MINI-BEAM required when powered by the Node
Hookup Diagrams
Node 1
Node 2
Gateway as I/O Repeater
Inputs 1-2
Outputs 1-2
An I/O repeater system uses the
Gateway to pass data between
Nodes.
DI1
DO1
GND
SP3
GND
A1+
A1−
SP1
DI2
DO2
GND
SP4
GND
A2+
A2−
SP2
MINI-BEAM
®
Power
DIx
GND
DOx
PWR
Sinking Input Wiring
Sinking Output Wiring
PWR
GND
AO2
AI2
PWR
GND
DO2
DI2
PWR
GND
AO1
AI1
PWR
GND
DO1
DI1
5-pin Euro-style Hookup (RS-485)
Wire Color Gateway 10–30V dc Node
1 Brown +10 to 30V dc Input +10 to 30V dc Input
2 White RS485/D1/B/+
3 Blue dc common (GND) dc common (GND)
4 Black RS485/D0/A/−
5 Gray Comms grnd
* Connecting dc power to the communication pins will cause permanent damage.