Manual
DIP Switch Configurable Gateway for the M-GAGE™ Node
Features
IP67 Base
2.4 GHz
IP20 Base
900 MHz
The SureCross™ wireless system is a radio frequency network with integrated I/O that
can operate in most environments while eliminating the need for wiring runs. Systems are
built around a Gateway, which acts as the wireless network master device, and one or
more Nodes.
• Gateway’s discrete inputs are mapped to baseline two M-GAGE™ Nodes; M-GAGE
inputs are mapped to the Gateway’s outputs
• Switch configurable to allow for user programmability of two M-GAGE Nodes
• 10 to 30V dc power input
• Modbus serial interface
• Site Survey analyzes the network’s signal strength and reliability
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple
Access (TDMA) control architecture combine to ensure reliable data delivery within
the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, in-
cluding fully acknowledged data transmission
• Lost link outputs on the Gateway
• The DX80...C models are certified for use in Class I, Division 2, Group A, B, C, D;
Zone 2 (Group IIC) Hazardous Locations when properly installed in accordance with
the National Electrical Code, the Canadian Electrical Code, LCIE/ATEX, or applicable
local codes/regulations (see Specifications)
For additional information, the most recent version of all documentation, and a complete
list of accessories, refer to Banner Engineering's website, www.bannerengineering.com/
surecross.
Models
Model Frequency Environmental Rating I/O
DX80G9M6S6P6ZP 900 MHz ISM Band
IP67, NEMA 6
Inputs: Selectable discrete
Outputs: Sourcing discrete
DX80G2M6S6P6ZP 2.4 GHz ISM Band
DX80G9M6S6P6ZPC 900 MHz ISM Band IP20, NEMA 1
Class I, Division 2, Group A, B, C, D
Hazardous Locations (see Specifica-
tions)
DX80G2M6S6P6ZPC 2.4 GHz ISM Band
Internal antenna models are also available, but are not UL Listed. For more information, contact your local Banner Engineering Corp.
representative.
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to seri-
ous injury or death. This product does NOT include the self-checking redundant circuitry necessary to
allow its use in personnel safety applications. A sensor failure or malfunction can cause either an ener-
gized or de-energized sensor output condition.
SureCross DX80 Gateway with Discrete I/O
P/N 139075 rev. D 1/11/2012
0 139075 9