Product Manual

Page 10 of 17
6. Repeat steps 1 through 3 until the pallet jack works in all three control positions.
Figure 5
Maintenance
Maintain the product by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from
oil and grease. The following chart is based on a normal operation schedule.
Maintenance Interval
Maintenance Point
Daily before operating
Daily inspection and maintenance of the pallet jack is required,
especially for the wheels and the axles. Remove thread or
rags on the wheel or axle if any is detected. Unload and lower
the forks to the lowest position after every job is finished.
Before and after operating
OIL. Check the oil level annually by removing the oil plug (48)
on top of the pump housing. When changing or adding oil, fill
the tank through the oil plug hole to 80% capacity with
hydraulic jack oil, about 2-1/2” deep in pump housing. See
Figure 6. Do not use any other type of oil. When finished,
replace oil plug (48).
Figure 6
LUBRICATION. Wheel bearings are sealed and require no
lubrication. The crankshaft features “oil lite” bushings that also
require no lubrication.