Installation Instructions

FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digita
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interfere
nce in a residential installation. This equipment generates, use
and can radiate radio frequency energy and, if not installed and used in accordance with t
he
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to c
orrect the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any ch
anges or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.