Warranty

10 ft (305 cm)
10 ft (305 cm)
90332 Banzai 3
safety area
Take the plunge down this huge 9 ft 6 in (290 cm) tall water slide into the giant
refreshing 12 ft (366 cm) diameter pool below! Big enough to fit family and friends, the
pool is sure to make a big splash all summer long. With the included continuous-airflow
blower motor, a whole backyard pool party inflates in under 3 minutes. Heavy-duty
Dura-Tech™ construction ensures lasting strength and durability while the constant
airflow helps resist small tears and punctures.
PLACEMENTS: Use on flat lawn only, not pavement or other hard surfaces. Lawn
should be free of rocks, bumps, depressions, sticks, etc. The product should be set up
in a location that has a minimum distance of 10 ft (305 cm) from any freestanding
structures or obstructions, including houses, garages, fences, trees, playground
equipment and large rocks.
INTRODUCTION
SETUP INSTRUCTIONS
Fig. A2Fig. A1 Fig. A3
Fig. A4 Fig. A5 Fig. A6
Fig. A7 Fig. A8 Fig. A9 Fig. A10
SETUP
1. Unfold the constant air inflatable and place in the desired position on a smooth and level surface.
2. Lay out the water hose assembly and match the number on each sprayer to the correct position on the arch of the
inflatable. Once the numbers are matched, attach the sprayers to the arch and corresponding position using the
Velcro straps provided. Secure the water tubing using the Velcro hooks & loops located on top of the arch, and
along the side of the inflatable. (Fig A1-A3)
3. Attach the long intake tube at the
back of the inflatable to the mouth
of the blower motor using the
attached Velcro Strap. To ensure a
secure fit, wrap the strap around
the mouth of the blower and
tightly attach the self-sticking
strap. (Fig A4-A6)
4. Use the drawstrings to tie shut the
short air release tube along the
back of the constant air inflatable.(Fig A7)
5. Position the blower in a straight line perpendicular and level to the back of the inflatable. The blower should be
placed on a stable surface and remain upright after the inflatable is inflated. The blower is a high-volume fan
capable of moving a lot of air very quickly. Place the blower in an area where it will not suck in dirt or leaves. Keep
blower away from children, water and moving vehicles. Set up the inflatable far away from any structures or
obstructions. Once positioned, secure the blower with the blower ground stakes provided.(Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard surfaces. A fall onto a hard surface can
result in serious injury.
7. Locate the loops around the bottom of the inflatable and anchor them to the turf, sand soil or rock soil with the
water slide ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no part of the stake is protruding above the
ground surface. This will help prevent tripping or injuries resulting from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The inflatable should inflate in under 3 minutes. Do
not allow children to use the inflatable until it is fully inflated.
10. Close the water valve at the bottom of the pool. (Fig A10)
11. Fill the pool with at least 8 in (20 cm) of water before playing. Thoroughly wet all slide surfaces, platforms and
climbing walls before use to ensure optimal play performance.
12. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
13. After inflation, the blower should run continuously while children are playing.