Warranty

90332 Banzai 6
Fig B1
Fig B2
Fig B3
Fig B4
Fig B5
Fig B8
Fig B7
Fig B6
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
containing a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded in accordance with all local codes and ordinances.
DANGER – Improper installation of the grounding plug can result in a risk of electric shock. If repair or
replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade
terminal. The wire with insulation having a green outer surface with or without yellow stripes is the
grounding wire.
Check with a qualified electrician or service technician if the grounding instructions are not completely
understood or if in doubt as to whether the product is properly grounded. Do not modify the plug
provided; if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
This product is for use on a nominal 120-V circuit and has a grounding plug similar to the plug illustrated
in Figure A. Only connect the product to an outlet having the same configuration as the plug. Do not use
an adapter with this product.
1. Check the inflatable at regular intervals for holes, tears or other damage. DO NOT use a damaged
inflatable. Use of a damaged inflatable could result in serious injury or death.
2. In addition to checking the product at a regular interval, be sure to complete a thorough check of the
entire product at the beginning of each season or series of use.
3. If any component of the product is damaged or deteriorated, discontinue use and contact the
manufacturer.
4. Regularly check the condition of the ground stakes that hold the inflatable in place. Damage to or
deterioration of the stakes could result in the inflatable becoming unstable, which could result in
serious injury.
5. To keep the product clean, you can use a dry cloth or a cloth dampened with a neutral,
non-inflammable, nontoxic cleaning and sanitizing solution or pure water to wipe the surface of the
inflatable or blower.
6. Use a dry cloth to clean the foot holes and remove debris after each play cycle. Make sure that there
are no water and debris in the pocket steps before storing.
Grounding methods
MAINTENANCE OF THE PLUNGE™
TO DEFLATE:
1. Remove all users from the product.
2. Turn off and disconnect the water hose from the plug.
3. Drain inflatable pool area by opening the water valve.
4. Completely dry off the inflatable by allowing it to stand inflated for
at least 2 hours before wiping down with a dry beach towel or
soft, absorbent cloth, noting deep pockets in the climbing wall
and the splash pool.
5. Unplug the blower.
6. Disconnect the long intake tube from the blower and place the
blower in a safe place.
7. Open the air release tube and allow the inflatable to deflate
completely. It should deflate on its own within 5 minutes. (Fig B1)
8. Remove the clear water tubing from the inflatable.
9. Remove the water slide stakes of the inflatable by pulling on the
head of the stakes. DO NOT pull on the inflatable corners!
10. Allow the inflatable to dry completely before rolling up, which may take up to 48 hours. Be sure
the pool and inflatable are free of dirt, leaves, sand, etc. This will lengthen the life of your
inflatable.
11. Fold the inflatable in half, making sure that the release tube is parallel to the fold. Fold it in half 2
more times, parallel to the first fold. (Fig B2-B3)
12. Roll the inflatable tightly starting from the end opposite the intake and release tubes. (Fig B4-B5)
13. Roll the inflatable tightly from one end to the other and avoid any creasing.
IMPORTANT:
Never store the product when wet. Allow to dry before rolling up.
Move the product every day to prevent browning or damage to the lawn.
Follow all previous instructions each time you set up the product.
Store the product in a secure place, away from children, to prevent suffocation.
STORAGE:
Slip the carrying bag over the rolled-up inflatable. Flip over the bag and the inflatable, close the bag,
and store the inflatable and the blower in a dry place. Store the inflatable in a secure place away
from children to prevent suffocation. Never leave either the product or the blower outside when not in
use. (Fig B6-B8)
To prevent mold and other damage to the inflatable, it is strongly advised to air dry the product with
the blower motor to ensure it is completely dry before folding up for storage.
To extend the life of the water spraying hose assembly, store it in an adequately ventilated area. Do
not store the water spraying hose assembly together with the inflatable.
GROUNDING INSTRUCTIONS