SAFETY INFORMATION: The following safety precautions shall always be observed during operation, service and repair of this equipment. » This equipment shall be serviced by qualified technicians only. + Do not modify the radio for any reason. » Use only GUOFENG supplied or approved batteries and chargers. + Do not use any portable radio that has a damaged antenna. If a damaged antenna comes into contact with your skin, a minor bum can result.
CONTENT FEATURES AND FUNCTIONS UNPACKING AND CHECKING EQUIPMENT OPTIONAL ACCESSORIES 4 BATTERY INSTALLATION — BATTERY CHARGING BATTERY INFORMATION INITIAL USE ~~ 05 11.CTCSSICS CSS TABLE DCS TABLE SHORTCUT MENU OPERATION SET MENU DESCRIPTION WARRANTY: (Better buy the radios from local dealer) —FEATURES AND FUNCTIONS: This is a GT-TWP dust and waterproof resisting two way radio. After 30 minutes inch one meter underwater, the radio still works very well.
OT-3WP UNPACKING AND CHECKING EQUIPMENT: Carefully unpack the transceiver. We recommend that you identify the items listed in the following before discarding the packing material. If any items are missing or have been damaged during shipment, please contact your dealers immediately. Note: Items included in the package, may differ from those listed in the table above depending on the country of purchase. For more information, census your dealer or vendor.
OT-3WP AR-3weP INSTALLATION OF EXTERNAL: Plug the external micro-headset connector Into the Jack of “SP. & MIC"of the transceiver as shown In the figure below. 4.BATTERY INSTALLATION: When attaching the battery, make sure the battery is in parallel and in good contact with the aluminum chassis. The battery bottom is about 1 fo 2 centimeters below the bottom of the radio's body. Align the battery with the guide rails on the aluminum chassis and slide It upwards until a “click” Is heard.
OT-3WP AR-3weP 4. Place the radio with the battery attached, or the battery alone, in the charger. 5. Make sure the battery is in good contact with the charging terminals. The charging process initiates when the red LED lights. 6. The green LED lights about 4 hours later indicating the battery is fully charged. Then remove the radio with the battery attached or the battery alone from the charger. BATTERY INFORMATION: INITIAL USE New batteries are shipped uncharged fully from the factory.
OT-3WP AR-3weP PARTS, CONTROLS AND KEYS: 1.RADIO OVERVIEW: nan) To 1 Antenna 6 Speaker 11. SiC aide kayaking 21h 7 Microphone 12 Strap buckle. 4 Keypad 8 Battery inch 13 Accessory jack 4. Knob (ON/OFF, volume} BIT: 14 LED indicator 5 Flashlight 10.
OT-3WP To cancel /clear or exit While standby, press [EXIT/AB] key to switch between Channel A and Channel B. Under FM radio mode, press [EXIT/AB] key to switch the FM radio band NUMERIC KEYPAD: oad Used to enter information for programming the radio's lists and OOO D the non-standard CSS Under transmission mode, press the numeric key to send the oa signal code( the code should be set by PC software).
OT-3WP AR-3weP a click’ is heard to tum the radio off. Tum the knob clockwise to increase the volume, or counterclockwise to decrease the volume Caution: The radio will not sound ‘click’ If you tum off the voles prompt function. The boot mode display can be set from Function 38 2.Transmit and Receive: Chooses the correct channel No. or enter the frequency which you need, Then press and hold PTT bunion, the radio is transmitting now, then talk to the microphone, your sound will be transmitted.
OT-3WP AR-3weP When the radio is on VFO mode, the frequency can be input by the keypad directly. oan not sleet a channel without previously stir OUTDRAW (Dual Watch/ Dual Reception) This feature allows you to operate between frequency A and frequency B. Periodically, the transceiver checks whether a signal is received on another frequency that we have scheduled. If you receive a signal, the unit will remain in the frequency until the revived signal disappears.
OT-3WP AR-3weP 4 Now through the MENU, you can set other parameters. CTCSS,DCS, RF Power, Bandwidth, etc. 5 After you finish all the other settings, press [MENU] key, then come to MENU 27, press [MENU] key two times, you will know all the data have been stored into CH106, however now only RX frequency was stored. At the same time, you press [MENU] key another two times, Note: if: int the TX freq 625 stored HI the same sips after store he 2 9.
OT-3WP AR-3weP 17 | Designation code only cooed be seedy PC software) | 1. 15 groups 18: resume method) OCTOBER. 19 PTT Dippers or relentless the PTT bunion to transmit he singe code) OFF/BOTEOT/BOTH 22 the algal coda sending) 0.
OT-3WP In "standby’ mode, tha transceiver transmits without pressing the “PTI. Check fhe level adjustment function "VOX is not TROUBLESHOOTING: Problem Possible cause / solution ‘The radio doss not start.
OT-3WP AR-3weP WARRANTY: (Better buy the radios from local ). Date of purchase: WARNING: purchase of equipment. ‘Warranty is valid provided it is complete and properly filled In legibly and clearly present the seal and name of the dealer and have attached the bill proof of WARRANTY CERTIFICATE Brand: Mendel no.
OT-3WP The warranty Is cold on the following assumptions: 1.Devices that have been manipulated by another or by anyone other than authorized service provider. 2 Equipment and accessories in which the serial number has been altered, deleted or filed unreadable.
