User's Manual

(28) Channel store - (Memory) - MENU No. 27
When the radio is in frequency working mode or standby mode, input the desired frequency or parameters directly.
NOTES: If you want to set CTCSS tones, DCS codes or the frequency offset, you have to do it before storing the channel.
The channels already stored are displayed as CH-XXX ("CH" and -channel number), and other channels only display
channel numbers.
(29) Channel Delete (Delete) - MENU No.28
In this menu you can delete a channel of the radio.
(30) Alarm Mode (Alarm Mode) - MENU No.29
This function can set the tone alarm/code alarm/site alarm of the radio.
Keep pressed the [FM/SOS] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• Site: the speaker emits an alarm tone but the radio doesn’t transmit;
• Tone: the speaker emits an alarm tone and the radio transmits it;
• Code: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(31) Scan of frequencies with CTCSS (SEEK CTC) - Menu No. 30
The function allows scanning the frequencies with CTCSS tone enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(32) Scan of frequencies with DCS (SEEK DCS) - Menu No. 31
This function allows scanning the frequencies with DCS code enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.