User's Manual

SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC with the device transmitting at its
highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be well below the maximum value. Before a new model is a
available for sale to the public, it must be tested and certified to the FCC/ISEDC that it does not exceed the exposure limit
established by the FCC/ISEDC Tests for each product are performed in positions and locations as required by the FCC/ISEDC.
For body worn operation, this device has been tested and meets the FCC/ISEDC RF exposure guidelines when used with an
accessory designated for this product or when used with and accessory that contains no metal.
To maintain compliance with the FCC/ISEDC’s RF exposure guidelines, hold the transmitter and antenna at least 1 inch(2.5
centimeters) from your face and speak in a normal voice, with the antenna pointed up and away from the face.
This equipment complies with FCC/ISEDC radiation exposure limits set forth for an uncontrolled environment. In order to
comply with the FCC/ISEDC RF exposure requirements, the antenna installation must comply with following:
Users must be fully aware of the hazards of the exposure and able to exercise control over their RF exposure to qualify for
the higher exposure limits.
Your wireless hand-held portable transceiver contains a low power transmitter. This product sends out radio frequency (RF)
signals when the Push-to-Talk (PTT) Button is pressed.
The device is authorized to operate at a duty factor not to exceed 50%.
Les tests SAR sont effectués en utilisant des positions de fonctionnement standard acceptées par la FCC/ISEDC avec l'appareil
transmettant à son niveau de puissance certifié le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR
soit déterminé au niveau de puissance certifié le plus élevé, le niveau SAR réel de l'appareil tout en fonctionnement peut
être bien en deçà de la valeur maximale. Avant qu'un nouveau modèle ne soit disponible à la vente au public, il doit être
testé et certifié par la FCC/ISEDC qu'il ne dépasse pas la limite d'exposition établie par la FCC/ISEDC Les tests pour chaque
produit sont effectués dans les positions et emplacements requis par la FCC/ISEDC.