Safety Information

6.2 Channel scanning
Use scan to search the channels for transmissions from unknown parties, to find someone in your group who has
accidentally changed channels or to quickly find unused channels for your own use.
a. In channels mode, press key for more than 2 seconds. The radio will start scanning according to the channel you
set.
b. You can change the scanning direction with the / keys.
c. Press key to stop scanning.
Note: for Scan mode, see Menu No.19.
6.3 CTCSS scanning
The function allows scanning the frequencies with CTCSS tone enabled.
a. In standby mode, press [3][0], “SEEK 67.0” will appear on the display.
b. Press and the scan of CTCSS tones will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.4 DCS scanning
This function allows scanning the frequencies with DCS code enabled.
a. In standby mode, press [3][1]; the display will show “SEEK D023N”.
b. Press and the scan of DCS codes will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.5 Cursor Conversion (A/B)
Directly press / key to move the cursor up and down. Then, you can modify or confirm the parameters indicated by
the cursor.
Important1: P15UV has a dual-frequency display function. In frequency mode, you will see on the display two different