Owner's Manual

Basic Operations
Power on/off and volume adjustment
Rotate the Power/Volume knob clockwise to turn the radio on. Rotate the control clockwise /counter-clockwise to adjust the
volume level as you prefer. To turn the radio off, rotate the control counter-clockwise till hearing a mechanical “click”.
Transmission
To communicate, all radios in your group must be set to the same channel. Briefly press the Monitor to enable the Monitor
feature in order to make sure that the frequency is not busy, and then press the PTT key. Release the PTT key to receive. Only
one user at a time can talk during radio communications. Therefore, it is important not to transmit when you are receiving a
communication and use the transmission mode sparingly to allow other users to talk. Transmission consumes a significant
amount of energy and should therefore be used sparingly to prolong the battery life. If you are unable to contact a station
that you have no problems in receiving, the station may be using CTCSS tones or DCS codes.
Monitor
The Monitor feature is for excluding (opening) the Squelch, in order to listen to signals that are too weak to keep the Squelch
permanently opened. Hold down the Monitor to enable such function.
Scan
This function can be activated only by means of the optional programming software. To enable the Scan function, all 16
channels must be programmed. If you turn on the radio on channel 16, the scanning will automatically start. Whenever any
signal is detected, the scanning will stop on a busy channel. If the PTT is pressed, you will transmit on the latest busy channel.
Channel 16 is the priority channel; therefore if you don’t pick up any signal when you press PTT, the radio will transmit on
channel 16.
Squelch
The Squelch function suppresses noises on free channels and allows receiving even weak signals. F100 has 10 different
Squelch levels that can be set by programming software: 0 means that the Squelch is turned off; from level 1 to level 9 you