Owner's Manual

explosion when charging alkaline batteries.
1) Turn the radio off.
2) With the back of the radio facing you, lift the battery cover latch up and remove the cover.
3) Insert the three AA Alkaline batteries with + and – polarity as shown inside (Installing the batteries incorrectly will prevent
the unit from operating or may damage the unit).
4) Close the battery cover. Replace the belt clip, making sure it locks into place.
External Speaker/Microphone Jack
Each radio can be used with an optional external speaker/microphone or headset, freeing your hands for other tasks. To use
an optional speaker / microphone or headset:
1) Open the rubber cap on the side of the radio.
2) Insert the plug(s) into the SPK/MIC jacks.
3) Place the ear bud into your ear, and adjust the Microphone into your desired position.
Using a Headset
You can use a headset (#480_5R) for more private communications. To use a headset, lift the rubber cover from over the
headset jack, and then plug in the headset.
Important: Your radio is not submersible or waterproof when using a headset jack. When you remove the headset, be sure
to fully press the jack cover into place to restore its waterproof capability.
Charging the Battery
Charging the Radio
Two radios can be charged directly by using the supplied charging cradle. A single radio can charge using the Type-C USB port
to connect to a USB power source. For fastest charging, turn off the radio before charging.
Warning!
To avoid the risk of personal injury or property damage from fire or electrical shock, only use the accessories specifically
designated for this product. Using the Type-C USB Port