Owner's Manual

the 105 DCS Codes. The Privacy Code icon on the display will indicate whether you set your Privacy Code in CTCSS or DCS
mode. To confirm the selection, press the [PTT] button or press the
button again to move to the next feature setting.
NOTE: If you select a CTCSS Privacy Code, any pre-selected DCS Privacy Code will be cancelled and vice-versa. Selecting a
Privacy Code of "oF" will disable the Privacy feature. To communicate between two radios, all radios in your group must be
set to the same channel and/or Privacy Code selections. The Privacy Code can only be set in channels 1~22.
2. VOX (Hands-Free Transmission)
Your radio has 3 VOX level settings: (oF/1/2/3).
To set VOX, press the
button until the display shows “VOX” blinking while on the right of the CHANNELNUMBER display,
an “oF” icon appears. Select “1”,“2” or “3” by pressing the
or buttons and push the [PTT] key, or press the
button again to move to the next feature setting.
VOX will be more sensitive on the “1” setting than on the “3” setting. To turn VOX off, press the
button until the display
shows “VOX” blinking while on the right of the CHANNELNUMBER display, a “1”,“2” or “3” icon appears. Select “oF” by
pressing the
or buttons and push the [PTT] key, or press the button again to move to the next feature
setting.
3. Ten Call Tone Settings
Your radio has 10 selectable CALLALERTS.
To select, press the
button until a “CA” icon appears and to the right of the “CA” icon the current CALLALERT setting is
displayed. Then press the or buttons to make the CALLALERT selections - the radio will emit a corresponding
tone for each selection. To confirm, press the [PTT] button or press the button to move to the next feature setting.
4. Emergency Alert Model
This function can set the off alert/ site alert/ tone alert of the radio. Keep pressed the [Emergency] button for 3 seconds to
start the alarm tone.
To select, press the button until a icon appears and to the right of the icon the current Emergency Alert