Owner's Manual

Your radio will rapidly scan each of the 22 channels and stop on any active channel. Your radio will resume scanning after 5
seconds when the channel is no longer active. When you press the [PTT] button to transmit on an active channel, the
scanning function will stop and remain on the active channel for 10 seconds before resuming scan when [PTT] button is no
longer pressed. To resume scanning, quickly press the
or button.
7. Scanning Sub-Codes
Press and holding [SCAN] button to enter the Sub-Codes scanning.
A flashing "CTC/DCS" will be in the left status display to indicate the radio is in Sub-Codes scanning mode.
In this mode, the lower display will cycle through the Sub-Codes as they are being tested. Once the bits of the received
Privacy code are determined, the "CTC/DCS" indicator will stop flashing.
Press the [PTT] button to save the scanned tone into memory.
8. Using the Flashlight
You can use this radio in an emergency. If you press [LAMP/Weather] button, the radio turns on the high-intensity LED
flashlight on your radio.
• Your radio operates normally when the emergency strobe is activated.
(1) Press [LAMP/Weather] button once, it will turn on continuously. (Always On mode)
(2) And then, press [LAMP/Weather] button once, the Strobe Light emits the emergency signal. (Strobe emergency mode)
(3) And then, press [LAMP/Weather] button once, the light will be turned off.
9. Emergency Alert
The Emergency Alert feature can be used to signal members in your group for help.
To activate the emergency alert function, press and hold the [Emergency] button on the top for 3 seconds. The radio will
send out a loud siren sound and the flashlight will flash.
Press the [Emergency] button to exit the emergency alert function.
WARNING: The Emergency Alert feature should only be used in the even of an actual emergency.