User's Manual

1. These symbols show that you set a DCS or CTCSS code in tx or rx. In tx mode it appears while you are
transmitting, while in rx mode it is shown also in stand-by condition.
2. Received signal strength.
3. Low power selection
4. This letter is displayed when the Dual Watch function is active.
5. VOX function enabled. (GMRS Version does not support)
6. Appears when a positive shift is activated.
7. Appears when a negative shift is enabled.
8. Reverse frequency
9. Narrow bandwidth: N = narrow. When the wide (W) bandwidth is activated, no icon is displayed.
10. This icon indicates the keypad lock. To unlock it press [# ] .
11. Battery level indicator. When the battery is almost used up, the icon starts blinking and the transmission is
blocked. Charge the radio.
12. Indicates the channel number that you stored
13. When the radio is in reception mode, this icon is displayed
14. Depending on the setting, it will show the frequency in use, the channel name, the menu setting, etc
15. Indicates the VFO in use and the current menu or function setting. This icon is displayed close to the band in
use or to the menu settings.
Battery Level Indicator
When the battery level indicator reads the battery is depleted. At this point the radio will start beeping
periodically as well as flash the backlight of the display and when voice prompts are enabled, a "Low Voltage"
announcement will be heard, indicating that you need to change your battery or put your radio in the charger.
4.3 Status Indications
The status LED has a very simple and traditional design.
LED Indicator
Radio Status
Constant Red
Transmitting.
Constant Green
Receiving.
4.4 Main keypad controls
• [SOS] key: Press it for a long time you will activate the alarm function. Press it again to turn off this feature.
• [SK1] key: Press it for a short time to turn on the FM radio. Press it again to turn it off.
• [SK2] key: Press it for a short time to light up the flashlight. If you push this button again, the flashlight will light
up to strobe mode. Press [SK2] a third time to turn off the flashlight.
To activate the Monitor function presses the button for a long time.
• [MENU] key: It is used for activating the MENU, choose each MENU selection and confirm the parameter.