User's Manual

EXAMPLE New memory in Channel 10:
RX = 462.5750 MHz
TX = 467.5750 MHz (This is a (+ 5) Offset)
TX CTCSS tone 123.0
a. Turn off the radio.
b. Hold press [MENU] key to open the radio, switching to the frequency mode.
Channel number at the right will disappear.
c. [MENU] [2][8] [MENU] [1] [0] [MENU] [EXIT] Deletes Prior Data in channel (Ex. 10)
d. [MENU] [1][3] [MENU] 123.0 [MENU] [EXIT] Selects desired TX encode tone
e. Enter RX frequency (Ex. 4625750)
f. [MENU] [2][7] [MENU] [1][0] [MENU] Enter the desired channel (Ex 10)
-->>[EXIT] RX has been added
g. Enter TX frequency (Ex. 4675750)
h. [MENU] [2][7] [MENU] [1][0] [MENU] Enter the same channel (Ex 10)
-->> [EXIT] TX has been added
i. In the off state, press and hold the [MENU] key to turn on the radio, return to MR mode, and the channel
number will reappear.
Ex 2. Programming a Simplex Channel with CTCSS tone
EXAMPLE New memory in Channel 10:
RX = 462.5750 MHz
TX CTCSS tone 123.0
a. Change from Menu to Menu by pressing the [EXIT] button.
b. The off state, hold press [MENU] key to open the radio, return to the frequency mode.
Channel number at the right will disappear.
c. [MENU] [2][8] [MENU] [1] [0] [MENU] [EXIT] Deletes Prior Data in channel (Ex. 10)
d. [MENU] [1][3] [MENU] 123.0 [MENU] [EXIT] Select desired TX encode tone (Ex 123 CTCSS)
-->>Use [EXIT] to select Upper display
e. Enter RX frequency (Ex. 462.5750)
f. [MENU] [2][7] [MENU] [1][0] [MENU] Enter the desired channel (Ex 10)
-->> [EXIT] Channel has been added
g. In the off state, press and hold the [MENU] key to turn on the radio, return to MR mode, and the channel
number will reappear.
6.12 Repeaters Programming
The following instructions assume that you know what transmit and receive frequencies your repeater employs,
and that you're authorized to use it.
a. Turn off the radio. Press and hold the [MENU] key to turn on the radio and return to the frequency（VFO) mode.
The channel number on the right will disappear.
b. Use the numeric keypad to enter the repeater's output (your receiving) frequency.
c. Press the [MENU] key to enter the menu.
d. Enter [2][6] on the numeric keypad to get to frequency offset.
e. Press [MENU] key to select.
f. Use the numerical keypad to enter the specified frequency offset. See the section called “26 OFFSET - Frequency