User's Manual

Chapter3. Installation of Accessories
Before the radio is ready for use we need to attach the antenna and battery pack, as well as charge the battery.
3.1 Installing/ Removing the Antenna
a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its
base and turning it clockwise until secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
3.2 Installing the belt clip
a. At the back of the battery there are two parallel screws mounted above the battery, remove these and thread them
through the holes on the belt clip as you screw them back into the battery body.
b. Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.
3.3 Installing the battery pack
Before attaching or removing the battery make sure your radio is turned off by turning the power/volume knob all the way
counter-clockwise.
a. Align the battery head with the back of the radio and install it on the radio.
b. Tighten the battery lock screw
Remove the battery pack
Loosen the battery lock screw until it separates from the radio, just lift the battery.