User's Manual

h. [MENU] [2][7] [MENU] [1][0] [MENU] Enter the same channel (Ex 10)
-->> [EXIT] TX has been added
i. [V/M] Return to MR Mode. Channel number will re-appear.
Ex 2. Programming a Simplex Channel with CTCSS tone
EXAMPLE New memory in Channel 10:
RX = 436.000 MHz
TX CTCSS tone 123.0
a. Change from Menu to Menu by pressing the [EXIT] button.
b. Set radio to VFO Mode by pressing [V/M]
Channel number at the right will disappear.
c. [MENU] [2][8] [MENU] [1] [0] [MENU] [EXIT] Deletes Prior Data in channel (Ex. 10)
d. [MENU] [1][3] [MENU] 123.0 [MENU] [EXIT] Select desired TX encode tone (Ex 123 CTCSS)
-->>Use [A/B] to select Upper display
e. Enter RX frequency (Ex. 436000)
f. [MENU] [2][7] [MENU] [1][0] [MENU] Enter the desired channel (Ex 10)
-->> [EXIT] Channel has been added
g. [V/M] Return to MR Mode. Channel number will re-appear.
6.11 Repeaters Programming
The following instructions assume that you know what transmit and receive frequencies your repeater employs, and that
you're authorized to use it.
a. Set the radio to Frequency (VFO) mode with the [V/M] key.
b. Enter the repeater’s output (your receiving) frequency by either using the
or keys, or by entering it directly on
the numerical keypad.
c. Press the [MENU] key to enter the menu.
d. Enter [2][6] on the numeric keypad to get to frequency offset.