User's Manual

The radio will stop scanning once a signal is detected.
(20) PTT-ID (PTT-ID) - MENU No.19
With this function you can decide when sending the ANI-ID code in tx mode.
You can choose amongst 4 possibilities.
• OFF: press PTT to turn it off
• BOT: the code is sent when you press the PTT
• EOT: the code is sent when the PTT is released
• BOTH: the code is sent when you press and release the PTT
Note: select ‘OFF’ when using in case of affecting the radio.
(21) PTT ID delay (PTT-LT) - MENU No.20
In this MENU you can set the delay time (0-30ms) sending the PTT-ID.
Note: select ‘0’ in normal using.
(22) Channel A Display Mode (MDF-A) - MENU No.21
This function is used to set the display mode of channel A.
Display modes:
• FREQ.: Frequency + channel No. • CH: Channel number
• NAME: Channel name
Note: Channel name mode must be set by the programming software. Up to three numbers or characters can be edited.
(23) Channel B Display Mode (MDF-B) - MENU No.22
This function is used to set the display mode of channel B.
Display modes:
• FREQ.: Frequency + channel No. • CH: Channel number
• NAME: Channel name