User's Manual

Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up to 5 digits each.

(19) SCAN Resume Mode (SC-REV) - MENU No.18

Thanks to this function, P52UV can SCAN in frequency or channel mode. You can choose amongst three options:

TO: Time-operated SCAN

Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds, and then will continue to SCAN

even if the signal is still present.

CO: Carrier-operated SCAN

Whenever a signal is detected, the radio will stop scanning. It will resume to SCAN once the signal will disappear.

SE: Search SCAN

The radio will stop scanning once a signal is detected.

(20) PTT-ID (PTT-ID) - MENU No.19

With this function you can decide when sending the ANI-ID code in tx mode.

You can choose amongst 4 possibilities.

• OFF: press PTT to turn it off

• BOT: the code is sent when you press the PTT

• EOT: the code is sent when the PTT is released

• BOTH: the code is sent when you press and release the PTT

Note: select ‘OFF’ when using in case of affecting the radio.

(21) PTT ID delay (PTT-LT) - MENU No.20

In this MENU you can set the delay time (0-30ms) sending the PTT-ID.

Note: select ‘0’ in normal using.

(22) Channel A Display Mode (MDF-A) - MENU No.21

This function is used to set the display mode of channel A.

Display modes:

• FREQ.: Frequency + channel No.

• CH: Channel number

• NAME: Channel name

Note: Channel name mode must be set by the programming software. Up to three numbers or characters can

be edited.

(23) Channel B Display Mode (MDF-B) - MENU No.22