Specifications

(5) Check hydraulic oil and brake fluid for leakage. Check if any leak or damage

found on the oil pipes, water hoses, vent-pipes and the piping joints, pumps and

valves etc.

(6) Check for all the terminals and plugs in normal state. Check the meters, lamps,

switches and electric circuit if they are running properly.

(7) Check every pedal for free stroke and the levers for looseness and smooth

operation. Check lifting system, actuate the lifting and tilting levers to be certain that

the lift bracket moves up and down properly and the mast can be tilted smoothly.

Check brake system and steering system for flexibility and reliability.

(8) Check the wheel brake: the free stroke of brake pedal is 4-8 mm, when

achieving effective brake, the clearance between the front floor and the pedal should

be more than 20mm.

(9) Check the parking brake: the unload forklift truck can park on 20% slope,

when the parking brake is locked.

(10) Check all connectors and fasteners for looseness.

3. Start and stop of the engine

(1) Start of the engine

(a) First set the shift lever at the neutral position and the parking brake at the

braking position.

(b) When starting, put the key into the start switch, turn it in the counter clockwise,

preheat 15-20 seconds, and then turn it in the clockwise to “START” so the starting

motor works. When your hand is away from the key, it automatically returns to “ON” by

spring force. Every starting time shouldn’t morn than 15 seconds. Restarting should

be after 2 minutes. As the engine doesn’t work after some times starting, should check

and remove the trouble, do not keep the starting motor engaged for a long time.

running for five minutes. Full load operation can’t be started until water temperature of

the engine rises above 60℃.

When the engine is on idle running, you must check water thermometer, oil

manometer, ammeter, fuel measurer, and so on for the data, whether to meet the

specification, and check each pedal for free stoke, braking performance for its reliability,