Specifications

8
have their appointed sling position. The above-mentioned data is only for a
reference, which may be adjusted because of configuration or technology
optimization.
(2) Load and unload the forklift truck
(a) Use the plate with enough length, width and strength.
(b) Pull the parking brake and use jacks to stop the wheel.
(c) Fasten the plate on the center of the cabin, there must be no grease on the
plate.
(d) The left and right height of the plate must be equal to make the loading and
unloading smooth.
(e) Don’t change the direction on the plate to prevent the danger.
(f) Reverse the forklift truck slowly when loading it on the freight car.
(3) Sling the forklift truck
(a) Only the specially trained personnel can sling the truck.
(b) Sling points should be always at the positions specified in sling nameplate.
(c) The slinging cable must be enough to hang the forklift truck.
(d) Disassembled parts of forklift truck must be slung in the appointed position.
(4) Towing of forklift truck
(a) The towing pin is installed below the counter weight. When towing the forklift
truck, first extract the pin and fasten a steel wire, then install the pin back.
(b) When towing the forklift truck, release the hand brake lever.
(c) The towing pin only used for following situation, while the forklift truck can’t
move or while transporting the forklift truck.
(d) Fasten the towing steel wire at the appointed position.
(e) Don’t apply capacity abruptly when towing the forklift truck.
(5) Repair the broken-down forklift truck
If the forklift truck broken-down suddenly during using, drag it away and repair in
time to avoid hindering other vehicles or workers.
5. Parking and storing