Specifications

11
operator shall be permitted to operate and service the truck.
(2) Wear the safety guards, such as clothing, shoes, helmet and gloves while
operating the truck.
(3) When operating the truck, observe and follow all nameplates stuck on the
truck. The nameplates must be replaced if lost or damaged.
(4) Daily maintenance should be done before or after using the truck. Anytime
you find that the truck is not functioning normally, operation of the truck should be
halted and check or repair at once.
(5) When the distance between the gravity center of loads and the fork arms is
600mm, the max. capacity is the rated capacity. When the distance exceeds 600mm,
the capacity shall be reduced according to the load chart. Overloading is strictly
prohibited.
(6) Operate your forklift truck on a hard ground. Operate on other ground, the lift
capacity and travel speed must be decreased. Wipe off the oil and grease from the
floor.
(7) If the forklift truck is equipped with attachment, its usage sphere will be wider,
but its allowable load and stability is reduced. The attachment and special device is
not to be diverted to any other purpose. It’s very dangerous to rebuild the attachment.
Please read the additional instruction we supplied and operate the truck following it
strictly.
(8) Users select “Lengthening fork” in order to carry widening loads. Pay much
attention not to overload and observe the allowable load and the capacity chart stuck
on the truck. Careful driving should be taken when traveling and turning.
(9) The unloaded forklift truck with attachment should be operated as a loaded
truck.
(10) Connect the power and turn on the key switch, select the position of direction
switch, check the truck for normal operation by turning steering wheel, depress the
speed-adjusting pedal softly to keep proper acceleration.
(11) During operation, pay attention to the performance and condition of the
system of machinery, hydraulic, electric and speed-adjuster etc.
(12) When operate one lever, pay attention not to shift another lever. Don’t
operate the lever at any position out of the driver’s seat.
(13) The shift distance of control valve lever can control the speed of the lifting or