Specifications

descending of the goods. When the goods are lifted or descended, the initial speed

shouldn’t be too fast in either case.

(14) When tilting the mast forward or backward to the limit or lifting the fork to the

maximum height, return the directional lever to neutral.

(15) The starting, turning, driving, braking and stopping of the truck should be

done smoothly. When turning on the humid or slippery road, the truck should be

decelerated.

(16) Because the forklift truck turns by the rear wheels, the end counterweight

may swing widely when turning. Use care in narrow aisles and other workplaces.

(17) Operate the forklift truck smoothly, don’t jerk the steering wheel. Avoid

sudden stop, acceleration, stop or turn. In the case of improper operation, the truck

will turn over. In case of this, the driver must keep calm, don’t jump off the truck. The

driver must hold tightly the control wheel with two hands; meanwhile, his body must

incline in opposite direction of truck’s turning over.

(18) Turning, lateral or deflective traveling shall not be taken on a slope. It could

cause overturning of the truck, it is very dangerous. On a slope, drive the truck with

load forward to ascend and backward to descend. When the truck goes down on a

slope, drive slowly with the brakes on. Make sure that the engine should not be shut

down when traveling on a slope.

(19) The stability of the truck is influenced by the wind-force during outside

operation, you must notice specially.

(20) Be careful and slow driving over a dock or temporary paving slab.

(21) Insert forks deeply under goods. Adjust fork’s distance according to the

dimension of goods. Make the loads distribute on the forks evenly to avoid tilt and

slide of goods.

(22) Don’t pick the loads with single fork. Fork can not be used to pull out any

embedded goods, if necessary, the pulling force should be estimated.

(23) Don’t handle unfixed or loose goods. Be careful to handle bulky goods. To

prevent the collapse of stacked goods, tighten them. Forbid loading loose or little

volume goods without pallet.

(24) When loading the goods, lower the forks to the floor. After the fork inserting

stacked goods, the fork arms should be in contact with the goods. Drive the truck with

mast tilting back for stabilizing the load. Before traveling, raise the forks for