Specifications

14
(39) Before the truck decelerating and stopping, don’t change gear to reverse
shift, so as to ensure the safe loading.
(40) When the truck stops and the engine is on idle position, the mast must be
tilted backward. You shouldn’t leave the truck with idling engine or hanged goods
unattended.
(41) When adding fuel, make the driver leave the truck and the engine flameout.
Don’t ignite when checking the level of fuel tank.
(42) Don’t open the radiator cap when the engine is very hot.
(43) After one day’s working, the fuel tank should be added oil to prevent the
humidity in the fuel tank from becoming the blob and then interfusing the fluid.
(44) When leaving, engage the hand brake, lower the forks on the ground and let
the shift lever to neutral, make the engine flameout or cut down the electric supply. If
parking on a slope with smaller gradient, apply the parking brake and block the wheels.
The truck is forbidden parking on a slope with bigger gradient.
(45) Don’t adjust the control valve and relief valve at will to prevent the damage of
hydraulic system and its components because of excessive pressure passing them.
(46) Tyres should be inflated according to the pressure value specified in the
nameplate of “Tyre Pressure”.
(47) Check the chains periodically to make sure that good lubrication condition
exists between the chain elements, the degree of tightness between left and right
chain is identical. If the variation value of the chain pitch exceeds 2% standard value,
it indicates that the chains have been worn excessively, replace it immediately.
(48) The overhead guard is main part which is strong enough to meet safety
standard, and protect the operator from falling materials. It’s very dangerous to
dismantle or rebuild the overhead guard, because these conditions could lead to an
accident.
(49) A load backrest shall be used as protection against back falling objects on
the fork. It’s very dangerous to dismantle or rebuild the load backrest, because these
conditions could lead to an accident.
(50) You can’t change or add other working equipments on the truck without our
company’s permission, or the rated capacity and safety operation will be affected.
(51) Keep safety when serving on high position.
(52) The forklift truck must be operated under the following environment: below