Specifications

38
(1) Dismantle heat spark plug and fuel injection pipe.
(2) Install manometer on the heat spark plug of 1st cylinder, the demarcate value
of the manometer is 500N/ cm
2
.
(3) Running the starting device by plenty battery, meter the pressure at this time.
(4) Measure the other 5 cylinder by the same way, and measure 2 times, then
figure out each average value; compression pressure: 304N/cm
2
(limit value
255N/cm
2
)
1.6.11 Exhaust of injection pump ( Fig 1.20)
(1) Loosen core vent of injection pump.
(2) Operate hand pump slowly till the core
vent doesn't bubbling.
(3) Tighten the core vent.
Fig.1.20
1.7 Precautions of cooling system
(1) During using the forklift truck, if the temperature of the radiator or coolant is
too high, don’t open the cap of the radiator immediately. To find the reason for boiling,
use extreme care when removing the cap, the sudden release of pressure can cause
a steam flash which would cause a serious personal injury. Lower the running speed
of the engine to moderate speed, after the cooling system cooled then turn to idle
speed, loosen cap slowly to allow steam to escape, the cap can be removed. After
that, make sure the cap is tightened securely.
(2) Check the radiator coolant reservoir fluid level. It should between FULL and
LOW mark. Add the same type coolant to specified level if necessary. The coolant can
be used all the year round.
(3) Put the coolant on a safe place and mark “Dangerous Matter” for its toxicity. If
swallowed by accident, take the emergency first aid and consult a physician
immediately.
(4) According to variety working condition, periodic wiping away the dirt adhering
to the surface of the radiator with detergent, compressed air or high pressure water
(pressure less than 4kg/cm
2
) is necessary.