Specifications

69
In order to keep the steering system in good working condition and avoid
accidents, it is necessary to check the steering system regularly. The structure of
steering unit is referred to Fig5.4.
(1) Regularly check water, foreign matter and acid number of the working oil, if
necessary, replace it with new oil.
(2) When checking the steering system, don’t disassembly the steering unit
readily, if the steering unit is in trouble, please ask professional service men to repair
it.
(3) Dismounting tool used and repair site must be clean. It would be the best
adopting indoor operations.
(4) Notes of assembling:
a. Wash all parties clearly with gasoline or kerosene before assembling, for there
is paint on the connection surface, it must be washed with acetone. You can’t wash
the parties with cotton yarn or cloth, but with brush, even clear away with compress air
if possible. Shouldn’t immerse the rubber in the gasoline for a long time. After
assembling the steering, join 50-100ml pressure oil in the orifice, turn the valve bore to
right and left, then install and practice the truck if they are not abnormal.
b. Valve body, block plate, stator, rotor and the connection surface of the back
cover must be kept clean, and they can’t be hurt.
c. Notice that the whorl cover most be lower than the surface of the valve body.
d. Block ring and slip ring have an inverse surface, the surface of block ring
should face the front cover, while the slip ring faces the valve bore.
e. There is mark on the surface of the rotor and interlock shaft, the mark must be
face to face when assembling.
f. The gasket of the bolt (with pin) must be cuprum or aluminum.
g. The method of riveting the seven bolt in the back cover: screw one by two in
order, not in turn but gradually, with the power of 30-40N.m.
h. When assembling the oil pipe, notice the mark “in”, “back”, “left”, “right” on the
valve body, they must be connected with the right oil pipe.
(5) Disassembly and assembly
a. Order of disassembly: front cover-block ring-slip ring-valve sleeve- (shim- shift
arm-valve core-spring piece)-back cover-spacing sleeve- stator-rotor- interlock
shaft-block plate-pin cover-steel ball-valve body.