Specifications

91
(3) Install shims between the top of the piston rod of the cylinder which stop first
and the upper beam of the inner mast. The thickness of the shim is 0.2mm or 0.5mm.
(4) Adjust the tightness of lift chains.
Fig8.3
Notice: Please pay more regard to safety when adjusting the lift cylinder at
an elevated height.
8.6.2 Carriage adjustment
(1) Park forklift on horizontal place and let mast vertical.
(2) Put the bottom of fork onto ground, screw the adjustable nut at the end of joint
and let main idler wheel come out l/4-l/3 of its radius. See Fig8.4.
Fig.8.4
(3) Lift fork to Max. height, and ensure gap B between limit blocks of fork and of
inner mast shall be 5-10mm. See Fig8.5.
(4) Put down the fork and tilt to specified position, adjust the nut at chain upside
and tensility of two chains should be same. See Fug8.6.