Specification Sheet
BAR’S LEAKS TECHNICAL BULLETIN
Tech Bulletin #: TB-1000-2
Page 1 of 2
Date 1
st
Issued: May 5, 2006
Date Revised: July 22, 2013
ISO 9001 CERTIFIED
Bar’s Leaks Engine Repair
Part #: 1000
Bar’s Products, 10386 N. Holly Rd., Holly MI 48442 USA
E-mail: info@barsproducts.com Web: www.barsleaks.com Phone: (800)345-6572
DIRECTIONS
● When Adding To Existing Engine Oil
Remove engine dipstick and check oil level. If oil
is low, remove oil cap and install entire contents
of the two chamber bottle. Do NOT overfill. Top
off with manufacturers recommended engine oil
as needed. Reinstall dipstick and oil cap.
Drive/idle engine for 10-15 minutes. Depending
on the engine problem, results will either be
immediate or noticeable within two (2) days or
100 miles of driving. In engines with seriously
damaged components, a second treatment may
be required. In this case, it is suggested that the
oil and filter be changed, and a second
application of Engine Repair be added.
● When Changing Oil
If using Engine Repair when changing oil, add
entire contents of bottle after filter is changed.
Then refill with manufacturer’s recommended oil
to proper level. Drive vehicle and recheck oil
level.
The common element between all of the engine components is the oil. Oil is the life-
blood of the engine and is pumped under pressure to all the moving parts. The two
main parts needing oil for lubrication are the bearings and pistons. As the engine
ages and gains more miles, the oil alone can’t do the job. Internally, parts don’t fit as
tightly as they originally did which causes noise and loss of power. Bearings wear
down, seals leak, lifters tick, blow-by passes around tired rings, and power is lost.
When installed, Engine Repair helps to stop and prevent these problems and will also
extend the useful life of your engine. Engine oils are generally used to reduce friction
between moving parts. In addition to lubricating, motor oil must cool, provide
corrosion protection and be a method of removing contaminants. As lubricants
degrade, their properties change, leading to increased friction and wear. Over time
the natural wear that occurs inside the engine causes reduced oil pressure, loss of
compression (power loss), lower fuel mileage, oil consumption (leaks & smoking) and
noise (knocking & ticking). Bar’s Leaks Engine Repair contains a combination of the
best performance additives to repair these most common oil-related problems. Engine
Repair restores lost compression and power, reduces noise and oil consumption,
while improving the performance of worn cylinders, rings, bearings, and seals. For
most vehicles, this is your last chance before paying an expensive repair bill or
replacing the vehicle. Engine Repair can be used to top off the existing oil when low,
or add a bottle when changing the oil & filter. Compatible with ALL types of engine
oils, including petroleum, synthetic and high-mileage formulas.
Part Number: 1000
UPC Item: 0 46087 01000 6
UPC Case: 1 00 46087 01000 3
Bottle Size: 16 fl. oz. (473ml)
Bottle Dimensions: 3.6 x 1.8 x 8.4
Bottle Cube: 54
Case Pack: 4 bottles per case
Case Size: 7.4 x 3.9 x 8.9
Case Cube: 257
Case Weight: 4.53 pounds
Pallet: TI 60 HI 5 Total 300
Pallet Height: 49 inches
ENGINE REPAIR
DOSAGE
1 bottle treats 4 to 6 quarts of oil