User's Manual

59
select “Enable” option, the following information needs to be entered
accordingly to the existing AP setting:
Encryption: Select “Disable” or one of WEP/WPA PSK/WPA2 PSK/ WPA
Enterprise/ WPA2 Enterprise.
Key: If Encryption is enabled, you have to enter a key according to the
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will pop up.)
Note: The Encryption and Key information must be consistent to the exiting
AP configuration.
<Apply >: Press “Apply” button after configuration, and follow the reboot instruction
when applicable.
<Cancel>: Press button to abort action.
10.8 SNMP Setup
 Enable or disable SNMP V3 service
 User Name: configure the user name to manage this device through SNMP
 Auth Password: configure the Auth password