™ Grind by Weight Accessory Operations Manual ESATTO shown with Preciso Grinder TM TM 1
™ TM Grind by Weight Accessory Table of Contents Introduction ................................................................................................ 2 Repeatability and Accuracy ........................................................................ 2 Parts Identification and Controls ................................................................ 3 Safety Information....... ............................................................................... 4 Assembly ............................
Introduction The Baratza ESATTO is a precision, weighing accessory that is designed specifically for use with your Baratza Maestro Plus , Virtuoso or Preciso or Encore grinders. This innovative addition to your grinder will allow you to grind precise dosages of coffee using real-time weight-based control. With its easy assembly and simple operation, you will be automatically dosing ground coffee to within + / - 0.15 gram repeatedly.
™ Parts Identification Grounds Bin Removable Rear Casting Weight Platform Start / Stop / Tare Button Weight Readout Window Weight Preset Buttons (3) Timer Knob Retainer Increase / Decrease Weight / grams 3
Safety Information Important Information Please read the information below very carefully. It contains important tips for the use, safety, maintenance and care of this appliance. Please keep these operating instructions for future reference. For Your Safety Do not operate the ESATTO with a damaged cord or plug, or if the ESATTO malfunctions. Do not leave your ESATTO unattended while turned ON. TM TM TM Caution Unplug the ESATTO from the electrical outlet before cleaning.
Assembly 1. Remove the grounds bin from the unit and set aside. 2. Remove the single Phillips head screw from the center rear of the rear metal casting cover and slide the rear casting rearward 1cm to remove it. (see photo #1). Photo #1 3. You must remove the rubber feet from the bottom of the grinder. Use a pair of side cutters or a butter knife to pry the feet out. (See photo #2). Photo #2 4. Coil the cord into the hole in the bottom of the grinder, about 1/3 will fit. (see photo #3). Photo #3 5.
6. Once the grinder is in place, plug the grinder cord into the AC receptacle inside the base of the ESATTO , and coil the remaining cord in the space under and behind the grinder. (see photo #6). TM Photo #6 7. Slide the cast metal cover into place from the rear, taking care to see that the front “fingers” lock into correct position. (see photo #7). 8. Replace the Phillips screw in the rear of the casting to secure the casting in place. Photo #7 9.
Operation and Programming displayed and temporarily stored in volatile memory, however, if the Esatto is unplugged, the new value will be “forgotten”. Start / Stop / Tare Press this button to start the grinder (after selecting a preset button (1,2 or 3). The grinder will stop automatically when the pre-programmed weight has been ground. If you’d like to stop the grinder sooner, press the button again.
Care and Cleaning If the weight display does not count up properly when grinding coffee, remove the grounds bin and blow air under the weighing platform to clear any coffee grounds from the narrow gap under the platform. DO NOT use any type of tool under the weighing platform. (See photo #10) Photo #10 The narrow gap under the weighing platform MUST be free of ground coffee.
Warranty and Service Length of Warranty: One-year from date of purchase. United States Warranty Information If your ESATTO fails within one year: e-mail: support@baratza.com or call 425-641-1245. Baratza will deliver an identical or comparable replacement to your door, free of charge, and arrange to have your “failed” unit returned to us. TM When you receive your replacement, please use the carton and packing material and the return shipping label supplied to return the “failed” unit to us.
Grinding Notes 10
© 2012 Baratza, LLC 3923-120th Ave. S.E. Bellevue, WA. 98006 www.baratza.