User Guide

ManualsBrandsBarber Colman ManualsHVAC Replacement Parts1/4" Compression Solenoid Air Valve w/ Junction Box (24V)

TAC

1354 Clifford Avenue

P. O. Box 2940

Loves Park, IL 61132-2940

www.tac.com

APPLICATION

For applications where an electrical circuit is used to

control a pneumatically-operated device. Used to direct

supply air to a pneumatic device when the coil is

energized or de-energized, depending on the supply

and exhaust air connects.

FEATURES

• Open frame or junction box construction

accommodates a wide variety of NEMA 1 mounting

locations.

• Available in 24, 120, 208, 240, or 480 Vac models.

• Supplied with 18" electrical leads for ease of

installation.

• Corrosion-resistant plastic body.

• Barbed fittings for 1/4" O.D. plastic tubing.

APPLICABLE LITERATURE

• TAC Cross-Reference Guide F-23638

• TAC Reference Manual F-21683

• TAC Application Manual F-21335

• EN-123 Air Quality Requirements for Pneumatic

HVAC Control Systems F-22516

AL-170 Series

AL-180 Series

Solenoid Air Valves

General Instructions

Summary of content (4 pages)

PAGE 1
TAC 1354 Clifford Avenue P. O. Box 2940 Loves Park, IL 61132-2940 www.tac.com AL-170 Series AL-180 Series Solenoid Air Valves General Instructions APPLICATION For applications where an electrical circuit is used to control a pneumatically-operated device. Used to direct supply air to a pneumatic device when the coil is energized or de-energized, depending on the supply and exhaust air connects. FEATURES • Open frame or junction box construction accommodates a wide variety of NEMA 1 mounting locations.
PAGE 2
SPECIFICATIONS Valve Inputs Power Input: 6.5 Watts (energized). Voltage: For available voltages, see Table-1. Electrical Connections: 18” (457 mm) leads on the coil. Maximum Inlet Air Pressure: 30 psig (207 kPa). Clean, dry, oil free air is required (reference EN-123). Air Connections: Three plastic ferrules included for plastic 1/4" tubing (PKG-1141). N.C., Normally closed, port 1. N.O., Normally open, port 2. COM, Common, port 3. Valve Outputs Flow Capacity: 0.
PAGE 3
INSTALLATION Inspection Inspect the carton for damage. If damaged, notify the appropriate carrier immediately. Inspect the device for obvious damage. Return damaged products. Requirements • Job wiring diagrams • Tools (not provided) • Training: Installer must be a qualified experienced technician. Warning: Disconnect the power supply (line power) before installation to prevent electrical shock and equipment damage.
PAGE 4
DIMENSIONAL DATA Figure-2 AL-170 Dimensional Drawing. Figure-3 AL-180 Dimensional Drawing. Copyright 2006, TAC All brand names, trademarks and registered trademarks are the property of their respective owners. Information contained within this document is subject to change without notice. TAC 1354 Clifford Avenue P.O. Box 2940 Loves Park, IL 61132-2940 F-24748-1 www.tac.