User Guide
24 Copyright 2007 TAC All Rights Reserved. F-27086-7
Valve Assemblies with Mx4D-703x and Mx4D-803x Spring Return TAC DuraDrive
Actuators
Actuator Specifications
Inputs
Control Signal
and
Power Requirements
All 24 Vac circuits are Class 2. All circuits 30 Vac and above are Class 1.
Connections Mx4D-703x-0x0 and Mx4D-803x-0x0: 3 ft. (0.9 m) long, appliance cable, 1/2 in. (13 mm)
conduit connector. For M20 Metric conduit, use AM-756 adaptor.
Mx4D-703x-1x0 and Mx4D-803x-1x0: 10 ft. (3.05 m) long, plenum cable, 1/2 in. (13 mm)
conduit connector. For M20 Metric conduit, use AM-756 adaptor.
Motor Type Brush DC.
Outputs
Electrical
Position Feedback Voltage: For 0 to 3 Vdc, 0 to 9 Vdc, and 0 to 10 Vdc proportional
actuators, the feedback signal is the same voltage range as the input signal. The 4 to 20 mA
proportional actuators and floating actuators have a 2 to 10 Vdc feedback signal. The feedback
signal can supply up to 0.5 mA to operate up to four additional slave actuators.
Mechanical Stroke: 93° nominal.
Manual Override: Allows positioning of valve shaft, using a manual crank.
Output torque rating: 30 lb-in (3.4 N-m).
RA/DA Jumper (Proportional Models): Permits selection of reverse acting or direct acting
control.
Position indicator: Visual indicator.
Part Number
for
Mx4D-703x-xxx
Mx4D-803x-xxx
Control Signal Voltage
Actuator Power Input
Running Holding
50/60 Hz
DC
Amps
50/60 Hz
VA W W
MA4D-x033-000
2 Position
SPST
24 Vac ±20% or
20 to 30 Vdc
5.1 3.6 0.14 1.3
MA4D-x033-100
MA4D-x030-000 120 Vac ±10% 50/60 Hz 7.8 5.0 — 2.5
MA4D-x031-000 230 Vac ±10% 50/60 Hz 7.2 5.2 — 2.4
MF4D-x033-000
Floating
24 Vac ±20% or
20 to 30 Vdc
6.8 4.2 0.15 1.9
MF4D-x033-100
MS4D-x033-000
2 to 10 Vdc
a
Proportional
a
4 to 20 mAdc with field-installed 500 Ω resistor.
6.1 3.4 0.12 1.4
MS4D-x033-100
MS4D-x033-020
0 to 3 Vdc
Proportional
MS4D-x033-120
MS4D-x033-030
6 to 9 Vdc
Proportional
MS4D-x033-130
MS4D-x033-050
0 to 10 Vdc
Proportional
MS4D-x033-150
MS4D-x033-060
4 to 20 mAdc
Proportional
MS4D-x033-160
Timing:
Part
Number
Approx. Timing in Sec. @ 70 °F (21 °C)
a
a
Timing was measured with no load applied to actuator.
Powered
Spring Return
CCW
b
b
CCW or CW as viewed from cover side of actuator.
CW
b
MA4D-703x 56 26 —
MF4D-703x
MS4D-703x
85 21 —
MA4D-803x 56 — 26
MF4D-803x
85 — 21
MS4D-803x