Installation Guide

INSTALLATION INSTRUCTIONS
P 847•244•1234 www.barclayproducts.com
12/21/07
Shower Assembly & Tub Mount Instructions
1. Turn off the water supply.
2. Align the valve assembly with the mounting flanges and secure with
the nuts on the mounting flanges. Rubber washer must be in place.
Tighten with a wrench.
Note: Flanges may be positioned up or down depending how high
you would like the spout placed and the hole spacing.
3. Apply teflon tape to both ends of the hot and cold supply nipples.
Thread the tapered ends of the nipples into the mounting flanges
on the outside of the tub. Thread the large locknuts and metal washers
onto the other ends of the nipples and secure the shower set to the tub.
4. Install a washer in the cradle nut and thread the cradle onto the valve
assembly. Tighten with a wrench.
5. Install washers on the hose ends and attach the hose to the cradle and shower head. DO NOT OVERTIGHTEN.
To Connect Shower Set to Tubes
1. First remove the round rubber washer from the end of each water supply tube and dispose of them.
2. Put the cone washers on the tub and connect the end of each water supply tube. Then slide the 1/2” connecting
nuts over the opposite ends of the supply tubes and up to the cone washers.
3. Twist the connecting nuts over the cone washers and thread the nuts onto the nipples.
4. Connect the other ends of the water supply tubes to your house water lines. Consult your local plumber for
assistance.
NOTE: Please seek professional help if you have copper plumbing in your home.
Cleaning Instructions
Wipe this whole set off with warm water and a soft cloth. DO NOT use soaps, cleansers, or brass cleaners as
they will disintegrate the protective lacquer coating and leave the brass exposed causing it to tarnish.
Parts Included
1 Valve Body 1 Shower Head 1 Hose 1 Cradle 4 Washers
2 Cone Washers 2 Large Locknuts 2 Connecting Nuts 2 (2 1/4”) Threaded Nipples
Tub Wall-Mounted
Faucet with
Hand Shower
Tools Needed
Adjustable Wrench Slip Joint Pliers Pipe Putty or Teflon Pipe Tape 2 Mounting Flanges Needed (NOT included)
NOTE: Handles are identified HOT and COLD. The hot handle must be to the left and cold to the right.
Be sure the water supply is turned off before starting installation. Cushion the wrench or slip
joint pliers with an old cloth to protect the finish of the fixture.
Cat. No.
4025

Summary of content (1 pages)