Installation Guide

Feet Installation
P 847•244•1234 www.barclayproducts.com
9/19/17
TUB FEET INSTALLATION WITH BAR
1. Place tub upside down onto a soft cloth/blanket to prevent from damage.
(Note: For roll top tub slide under rim 2X4 wooden block to elevate the tub from one side. This will
help turn the tub over when finished)
2. Once the tub is turned upside down remove washers and nuts from the
threaded studs.
3. Position mounting bars over the threaded studs on both ends.
4. After bars are in place thread a washer and nut onto each stud by hand. Do
not tighten until foot is attached. (Shown in image 1)
5. Attach feet onto the bars using flat washer, locking washer and bolt.
(Shown in Image 2)
6 . Finish tightening the bars once the feet are attached securely
(DO NOT OVER TIGHTEN MAY CRACK THE TUB)
7 . Lift tub by the rim and turn onto its feet. If tub is not level use built-in
adjuster under the foot. DO NOT LIFT TUB BY FEET
Tools Needed
• 11/16 Wrench • 3/4” Wrench •
Parts Included
• 2 Bars • 4 Mounting Bolts • 4 Flat Washers • 6 Locking Washers • 6 Nuts •
A. Roll top tubs have the drain located at the end of the tub and tilt toward the drain so
the two tallest feet must be attached on the end without the drain. The two shortest
feet must be attached on the drain end.
B. Double roll top and double slipper tubs have the drain located in the center of the
tub so no tilt is necessary as the bottom is slanted toward the drain. All four feet
should be the same.
Page 2