Installation Guide

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

9/14/09

1. Attach the bent corner rods to the straight rods by sliding on to the gray inserts on straight rods.

2. The large straight rod fits into the #331 D-Rod loops.

3. The looped portion of the #331 fits over the D-Rod corner pieces as shown.

4. The flanges attach to the wall (measure for proper distance).

5. The D-Rod assembly fits into flanges and is secured with set screws.

***** To attach faucet assembly: use #336 Double eye loop (sold separately)*****

6. The #336 double eye loop must be put on the desired side of the D-Rod before

back straight rod is attached.

7. The riser for the faucet assembly will fit through the other opening in the #336.

Parts Included

• 2 Corner pieces • 1 Back bar (no inserts) • 1 Front bar with grey inserts •

• 2 #331 D-Rod loops • 2 #300 Flanges • 8 Wall screws • 2 Set screws •

Cat. No.

4145

“D”

Shower Rod

Tools Needed

• Pencil • Drill • Measuring Tape •

PAGE 1
“D” Shower Rod Cat. No. 4145 INSTALLATION INSTRUCTIONS Parts Included • 2 Corner pieces • 1 Back bar (no inserts) • 1 Front bar with grey inserts • • 2 #331 D-Rod loops • 2 #300 Flanges • 8 Wall screws • 2 Set screws • Tools Needed • Pencil • Drill • Measuring Tape • 1. Attach the bent corner rods to the straight rods by sliding on to the gray inserts on straight rods. 2. The large straight rod fits into the #331 D-Rod loops. 3. The looped portion of the #331 fits over the D-Rod corner pieces as shown.