Installation Guide

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

4/14/09

1. Before beginning any work be sure to shut off the water supply.

2. Apply teflon tape to ends of both the hot and cold supply nipples.

Place valve body through holes in tub. Thread the large locknuts

onto the other ends of the nipples and secure the shower set to the tub.

3. Assemble shower head to gooseneck riser pipe.

4. Slip the wall bracket over the straight end of the riser pipe. Carefully slide

the bracket to the appropriate position (approximately half-way up the rod)

and tighten the set screw provided.

5. Assemble riser pipe to the riser coupling assembly on the spout by

tightening the coupling nut. After hand tightening, fasten securely by

using a wrench.

6. Secure wall support bracket to the wall using the wood screws provided.

7. Turn on water supply.

NOTE: Please seek professional help if you have copper plumbing in your home.

Cleaning Instructions

Wipe this whole set off with warm water and a soft cloth. DO NOT use soaps, cleansers, or brass cleaners as

they will disintegrate the protective lacquer coating and leave the brass exposed causing it to tarnish.

Parts Included

● Tub Spout #195-S ● Gooseneck Riser Pipe #196-R ●

● Wall Support Bracket w/ Screws #4195-WS ● Shower Head #1003

Rectangular

Shower Unit

Tools Needed

• Screwdriver • Level • 1/4” Drill Bit • Wrench • Wood Screws • Set Screw •

Cat. No.

4190, 4192

Pg. 1

PAGE 1
Rectangular Shower Unit Cat. No. 4190, 4192 INSTALLATION INSTRUCTIONS Parts Included ● Tub Spout #195-S ● Gooseneck Riser Pipe #196-R ● ● Wall Support Bracket w/ Screws #4195-WS ● Shower Head #1003 Tools Needed • Screwdriver • Level • 1/4” Drill Bit • Wrench • Wood Screws • Set Screw • 1. Before beginning any work be sure to shut off the water supply. 2. Apply teflon tape to ends of both the hot and cold supply nipples. Place valve body through holes in tub.
PAGE 2
Rectangular Shower Unit Cat. No. 4190, 4192 INSTALLATION INSTRUCTIONS Parts Included: • 2 Curtain Frame Sections • 1 Wall Tee • 1 Ceiling Tee • • 1 Wall Support 10” Long • 1 Ceiling Support 30” Long • 2 Flanges • • 4 Wood Screws • 10 Set Screws w/ Heads • 1 Headless Set Screw • 1. Connect both halves of the curtain frame (1) using the ceiling tees and wall tees as shown above. In order to insure a solid fit, the tees fit snugly over the frame tube. Install 4 set screws in each tee. 2.