Installation Guide

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

4/20/09

1. Before beginning any work be sure to shut off the water supply.

2. Apply teflon tape to ends of both the hot and cold supply nipples.

Place valve body through holes in tub. Thread the large locknuts

onto the other ends of the nipples and secure the shower set to the tub.

3. Assemble shower head to gooseneck riser pipe.

4. Assemble riser pipe to the riser coupling assembly on the spout by

tightening the coupling nut. After hand tightening, fasten securely by

using a wrench.

5. Secure wall support bracket to the wall using the wood screws provided.

6. Turn on water supply.

NOTE: Please seek professional help if you have copper plumbing in your home.

Cleaning Instructions

Wipe this whole set off with warm water and a soft cloth. DO NOT use soaps, cleansers, or brass cleaners as

they will disintegrate the protective lacquer coating and leave the brass exposed causing it to tarnish.

Parts Included

● Tub Spout #195-S ● Gooseneck Riser Pipe #196-R ●

● Wall Support Bracket w/ Screws #4195-WS ● Shower Head #1003

Rectangular “D”

Shower Unit

Tools Needed

• Screwdriver • Level • 1/4” Drill Bit • Wrench • Wood Screws • Set Screw •

Cat. No.

4193

Pg. 1

PAGE 1
Rectangular “D” Shower Unit Cat. No. 4193 INSTALLATION INSTRUCTIONS Parts Included ● Tub Spout #195-S ● Gooseneck Riser Pipe #196-R ● ● Wall Support Bracket w/ Screws #4195-WS ● Shower Head #1003 Tools Needed • Screwdriver • Level • 1/4” Drill Bit • Wrench • Wood Screws • Set Screw • 1. Before beginning any work be sure to shut off the water supply. 2. Apply teflon tape to ends of both the hot and cold supply nipples. Place valve body through holes in tub.
PAGE 2
Rectangular “D” Shower Unit Cat. No. 4193 INSTALLATION INSTRUCTIONS Parts Included: • 2 Corner pieces • 1 Back bar (no inserts) • 1 Front bar with grey inserts • • 2 #331 D-Rod loops • 2 #300 Flanges • 8 Wall screws • 2 Set screws • • # 336 Double Eye Loop • Tools Needed • Pencil • Drill • Measuring Tape • 1. Attach the bent corner rods to the straight rods by sliding them on to the gray inserts in straight rods. 2. The large straight rod fits into the #331 D-Rod loops. 3.