Installation & Assembly

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

3/28/18

Kitchen Wall Mount Faucet

Tools Needed

• Adjustable Wrench • Slip Joint Pliers • Pipe Putty or Teflon Pipe Tape •

1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avoid losing small parts.

2. Thread Flanges over nipples for water supply using teflon tape.

3. Thread Wall Connectors on to Flanges using teflon tape.

4. Connect Faucet Body to Wall Connectors using teflon tape.

5. Attach handles to faucet body.

6. For models with soap dish, thread post into back of faucet body and attached soap dish.

7. Turn on your new faucet for the first time. Allow both hot and cold water to run for one minute.

NOTE: 1. Use teflon tape on all threaded connections.

2. Flush line before faucet installation to remove debris

3. Take care not to keep plumber’s putty on any finish to corrode finish of faucet surface.

4. Take care not to damage the finish with tools during installation.

Care and Maintenance:

1. To clean, simply wipe with a clean soft cloth.

2. Please do not use sponge. Also, do not use abrasive cleansers or solvents to clean the faucet.

Parts Included

• Faucet body with spout • 2 Handles • 2 Flanges • 2 Wall Connectors with rubber washers

PAGE 1
Kitchen Wall Mount Faucet INSTALLATION INSTRUCTIONS Parts Included • Faucet body with spout • 2 Handles • 2 Flanges • 2 Wall Connectors with rubber washers Tools Needed • Adjustable Wrench • Slip Joint Pliers • Pipe Putty or Teflon Pipe Tape • 1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avoid losing small parts. 2. Thread Flanges over nipples for water supply using teflon tape. 3. Thread Wall Connectors on to Flanges using teflon tape. 4.