Installation Guide

1. Stick adhesive pad onto underside of each adjustable foot. Then screw

adjustable feet into threaded sleeves in support legs.

2. Screw two cam-bolts into nylon sleeves on the side of each support leg.

3. Offer front rail and rear wall plate dowels onto left support leg and press in.

4. Dowel joints are intentionally tight. If necessary tap into position using a hammer and a flat

smooth timber block to protect support leg.

5. Insert locking cams and tighten clockwise with screwdriver.

6. Turn left support leg into position shown, insert towel rail and offer right support leg onto dowels

and press in. Then insert locking cams and tighten clockwise with screwdriver.

7. Screw two cam-bolts for the shelf into the nylon sleeves or the rear of each support leg. Insert shelf onto cam-bolts as shown, then

insert locking cams and tighten clockwise with screwdriver.

8. Insert end stops of suspension cables through underside of frame assembly near wall plate. Then clip cone washer under the end

stops, tighten grub screws with small allen key and pull cables back down to secure.

9. Insert the cylindrical cable anchors into recesses in back edge of the shelf and secure with the cable retaining bolts using the large

allen key provided. DO NOT over tighten these bolts as they will be used to adjust and level the shelf.

10. Turn stand upright and lean it against the wall. Correct position carefully and check with a level. Rotate adjustable feet to compensate

for an uneven floor if necessary. Mark position of wall plate fixing screw holes, then remove stand and drill and plug fixing holes as

required. Return stand into correct position and screw it back into the wall.

11. Adjust shelf level and tension of support cables with the cable retaining bolts and large allen key. Finally secure retaining bolts in

place with grub screws and small allen key.

12. Insert cylindrical washstand supports as shown. Screw flat discs into supports and apply silicone adhesive into circular recess on top

face. Carefully lower top into position and leave to “cure” in accordance with manufactures instructions.

13. Finally bond ceramic backsplash to wall and stand top using clear silicone adhesive, removing any surplus adhesive promptly in

accordance with the manufactures instructions.

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

1/9/08

Parts Included

• 1 Left Support Leg (1) • 1 Right Support Leg (2) • 1 Front Rail (3) •

• 1 Wall Plate (4) • 1 Lattice Shelf (5) • 1 Towel Rail (6) • 2 Adjustable Feet (7) •

• 4 Supports for Porcelain Top (8) • 4 Discs (9) • 8 Cam-Bolts (10) • 8 Locking Cams (11) •

• 2 Screws & Wall Plugs (12a-b) • 2 Suspension Cables & Anchors (13) • Large Allen Key •

• Small Allen Key • 2 Cone Washers with Set Screws (14) • 2 Cable Retaining Bolts (15) •

• 2 Set Screws for Cable anchors (16) • 1 Porcelain Top (17) • 1 Porcelain Back-splash (18) •

Single Basin

Stand

Tools Needed

• Phillips Screwdriver •

• Hammer •

• Block of Wood •

• Level •

• Silicone Adhesive •

Cat. No.

SBS

12 13