User's Manual

System manual MeDis 5MP1HM 38
Setting the Resolution of Your 5MP1HM
1. To set the resolution for your high resolution display(s), right click
on the desktop and select Properties. Select the Settings tab
(see figure 16). Now select the rectangle that represents the
virtual display of the BarcoMed 5MP1HM Display Controller you
are working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed 5MP1HM, the resolution for the virtual display will be set
to a VGA resolution of 640 x 480 pixels. If you are NOT using the
VGA capabilities of your BarcoMed 5MP1HM, the display may not
be enabled yet. To enable the display check the Extend my
Windows desktop onto this monitor checkbox. Do not click the
Apply button at this time.
2. Click on the Advanced Button.
3. Select the Adapter tab and then click on the List All Modes
button. Select the desired resolution from the list and click OK.
The chart on the next page contains a partial list of the possible
Windows virtual desktop resolutions that might be available for
your configuration.
For example:
2048x2560256 at 71Hz.
NOTE: If you are using dual-headed display controllers, the
resolution will be the size of your virtual desktop.
4. Click OK on the bottom of the Adapter Control Panel. If the
OK button on the bottom of the Adapter Control Panel is not
visible, press the Tab key once and then Enter to select
OK.
5. Click OK in the Windows will now apply your new desktop
settings dialog box. Your high resolution display(s) should now
synchronize and display the Windows desktop.
6. Click Yes when asked, Your desktop has been reconfigured. Do
you want to keep these settings?
Repeat steps 1  6 for each BarcoMed 5MP1HM Display Controllers
installed in your system.
BarcoMed driver and software installation