User's Manual

2. Xenon bulb lamp replacement process
2,5 Nm
A
Image 2-15
11.Reinstall the side cover of the lamp house as illustrated.
Note: Please ensure that the thumb screws turning wire s are flash with the cover or interference w ill occur w hile inserting the
lamp hous e into the projector.
Image 2-16
CAUTION: The “LAMP INFO” parameters which are stored on a chip inside the lamp house MUST be updated
after each installation of an xenon bulb lamp inside the lamp house. Neglecting this update will result in poor
performance an d short life time of the xeno n bulb lam p. See procedure "Resetting the lamp parameters", page
20.
A realignment of t he xenon bulb lamp in its reflect or is required after the installation of the xenon bulb lam p
in the lamp house. See p rocedure "Realignment of the lam p in its reflector", page 21.
R59770175 XENON BULB LAMP REPLACEMENT 24/09/2008 17