Instruction manual

ScreenPRO-II Controller • User’s Guide 239
6. Operations
Using Move
mêçÖê~ã=~=jçîÉ=çå=mêçÖê~ã
This mode enables you to program a move with the layer on both Program and Preview —
after the layer has transitioned to Program.
 Use the following steps to program a move on Program:
1. In the Layer Control Section, select the layer (on Program) that you want to
move (
LAYER A or LAYER B). The button blinks to indicate that it is active for
modification. Note that its current position is the move’s "starting" location.
2. In the Layer Functions Section, press Move Setup. The button blinks to
indicate that you are now actively defining the properties of the move.
3. Size and position the PIP or Key to its “ending” location. Note that on Preview,
only the raster box moves.
4. Press Move Setup again to complete the programming. The button remains lit,
and the raster box returns to its starting location on Preview.
5. To set up an additional move on the other layer (provided that you are in Split
Layer
mode), repeat the procedure from step 1.
To pend and trigger the move, refer to the "
Pending and Triggering Moves" section.
mÉåÇáåÖ=~åÇ=qêáÖÖÉêáåÖ=jçîÉë
For each layer on which you have programmed an associated move, you can “pend” and
"trigger" the move in one of two ways — on
Preview or on Program.
• Pend on Preview
• Pend on Program
mÉåÇ=çå=mêÉîáÉï
This "pend" method enables you to move the PIP or Key automatically on the next
transition.
 Use the following steps to pend a move on Preview:
1. With the move properly programmed, ensure that the layer containing a move is
selected and blinking.
2. To pend the move, press Move in the Layer Functions Section. The button
lights to indicate the pending move. On Preview, the raster box blinks at the
"destination" location —
not the PIP or Key’s current location.
3. Perform a CUT or AUTO TRANS. The transition takes the Preview image to air,
and the move begins immediately on both Program and Preview.
4. To move the layer back to keyframe 1, press Move. The button lights and on
Preview, the raster box blinks at the "starting" location.
5. Perform a CUT or AUTO TRANS. In this "ping-pong" manner, you can continue
to transit back and forth between keyframes 1 and 2.