Instruction manual

ScreenPRO-II Controller • User’s Guide 251
6. Operations
Using the LOGO
rëáåÖ=íÜÉ=ildl
 Use the following steps to transition the LOGO to Program:
1. Ensure that the LOGO is properly set up. In Chapter 5, refer to the "LOGO Setup
Procedure" section on page 212 for instructions.
2. In the Layer Control Section, press LOGO to display the LOGO Menu.
3. On the Type line, selects the desired LOGO source — Black, or a captured still
frame (
FG_1, FG_2 or FG_3).
4. Perform a CUT or AUTO TRANS.
5. Clear the LOGO from Program in the normal manner — by clearing its layer from
Preview and then transitioning.
Please note:
• In addition to its use as a full screen downstream graphic (with the highest visual
layer priority), the
LOGO layer can also be used as a convenient “black preview”
function. This enables you to fade to black at any time, from any simple or
complex setup, without affecting the underlying "look."
• After a transition, the LOGO layer is automatically cleared from Preview. In this
way the next transition will always fade up from black to your previous setup.
LOGO