TLD (2.0-2.
Barco nv Presentations Noordlaan 5, 8520 Kuurne Phone: +32 56.36.82.11 Fax: +32 56.35.86.51 E-mail: presentations.bid@barco.com Visit us at the web: www.barco.
Copyright © All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be recorded, transmitted or stored in a retrieval system without the prior written consent of Barco. Changes Barco provides this manual ’as is’ without warranty of any kind, either expressed or implied, including but not limited to the implied warranties or merchantability and fitness for a particular purpose.
Table of contents TABLE OF CONTENTS 1. TLD (2.0-2.8:1) Lens Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1.1 1.2 1.3 1.4 1.5 1.6 Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table of contents 2 R5976221 TLD (2.0-2.
1. TLD (2.0-2.8:1) Lens Kit 1. TLD (2.0-2.8:1) LENS KIT 1.1 Kit Contents Kit Contents Contents • TLD (2.0-2.8:1) Lens. • Installation Manual. • Toraysee TM Cloth. 1.2 Removing the installed lens What has to be done? Removing the installed lens on the SLM series projector. Necessary Tools No tools necessary. WARNING: Risk of personal injury. Instructions for lens installation must be followed thoroughly. How to remove the installed lens? To remove the lens, follow the next procedure: 1.
1. TLD (2.0-2.8:1) Lens Kit Image 1-2 Move the handle of the lens anchor system to the left Image 1-3 Take the lens out of the lens block 1.3 Installing the new lens What has to be done? This new lens has to be installed on the SLM series projector. Necessary Tools No tools necessary. WARNING: Risk of personal injury. Instructions for lens installation must be followed thoroughly. How to install the new lens? To install the lens, follow the next procedure: 1.
1. TLD (2.0-2.8:1) Lens Kit 3. Push the lens, motors at the top, in the lens block gap horizontally, lining up the motor connector on the lens with the connector on the lens block (B), until the lens clicks in the lens anchor system. Caution: For a table mounted projector, hold the projector when pushing the lens into the lens block to avoid sliding off from the table. Image 1-4 Lens installation 1.4 Quick Lens Adjustment Quick zoom/focus adjustment 1. Press the Selection key *, Barco key.
1. TLD (2.0-2.8:1) Lens Kit LENS ADJUSTMENT SHIFT SHIFT with or , or to zoom/focus to return Image 1-6 Press the selection key * to switch to another pattern. Different patterns are available. 1.
1. TLD (2.0-2.8:1) Lens Kit RLM Projector RLM G5 (*) RLM G5+ (*) RLM H5 (*) RLM R6+ Formula (in meter) Formula (in inches) PD min = 2.52 x SW - 0.14 PD min = 2.52 x SW - 5.51 PD max = 3.58 x SW - 0.21 PD max = 3.58 x SW - 8.27 PD min = 2.52 x SW - 0.14 PD min = 2.52 x SW - 5.51 PD max = 3.58 x SW - 0.21 PD max = 3.58 x SW - 8.27 PD min = 2.02 x SW - 0.14 PD min = 2.02 x SW - 5.51 PD max = 2.86 x SW - 0.21 PD max = 2.86 x SW - 8.27 PD min = 1.85 x SW - 0.14 PD min = 1.85 x SW - 5.
1. TLD (2.0-2.8:1) Lens Kit 8 R5976221 TLD (2.0-2.
Revision Sheet To: Barco nv Presentations Noordlaan 5, 8520 Kuurne Phone: +32 56.36.82.11, Fax: +32 56.35.86.51 E-mail: presentations.bid@barco.com, Web: www.barco.com From: Date: Please correct the following points in this documentation (R5976221/03): page R5976221 wrong TLD (2.0-2.
