Installation manual

Installation Adjustments
7-2 ___________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
Installation mode start up
It will be necessary to perform several mechanical adjustments while in the installation mode. Remove the top cover in order to
gain access to the adjustment points (see Access to Controls).
Two possible ways to enter the installation mode :
a) Using the RCU.
Press the ADJUST key.
The projector displays the path selection menu.
b) Using the local keypad.
Press the ADJUST key.
The projector displays the GENERAL ACCESS.
Use the control disc to highlight ENTER ADJUST and press ENTER. The path SELECTION menu will be displayed.
Push the control disc up or down to highlight INSTALLATION and press ENTER.
ENTER continues displaying a WARNING.
EXIT returns to operational mode.
ADJUST returns to operational mode.
A warning will be displayed on the screen.
If you are qualified installation or service personnel, press ENTER to start up the installation mode.
When entering the installation mode, the projector will automatically switch to the internal pattern on 32 kHz/50 Hz.
ADJ
U
S
T
STANDBY
E
N
T
E
R
E
X
I
T
MAIN MENU
Image Control
Function Keys
Service Menus
Select with or
then <ENTER>
<EXIT> to return.
WARNING
RISK OF INCORRECT
ADJUSTMENT OF THE
PROJECTOR.
The following service menus are
reserved to, and to be performed
only by qualified personnel !
If qualified, press <ENTER> to
continue, or if not, <EXIT> to
return.
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with or
then <ENTER>
<EXIT> to return.
GENERAL ACCESS
5 6
3 4 BRIGHTNESS
1 2 CONTRAST
Enter ADJUST
Select with , , or ,
then <ENTER>;
<EXIT> to return.
MAIN MENU
Image Control
Function Keys
Service Menus
Select with or
then <ENTER>
<EXIT> to return.
WARNING
RISK OF INCORRECT
ADJUSTMENT OF THE
PROJECTOR.
The following service menus are
reserved to, and to be performed
only by qualified personnel !
If qualified, press <ENTER> to
continue, or if not, <EXIT> to
return.
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with or
then <ENTER>
<EXIT> to return.