Installation manual

Installation Adjustments
7-6 ___________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
CRT projection angle adjustment
The projection angle of the red and blue CRT's is dependent on the desired size of the projected image. If the centers of green,
blue and red do not coincide, the CRT projection angle must be adjusted. Never try to correct this misalignment with the shift
correction or the static convergence controls. These controls may only be applied to correct small errors which cannot be
corrected by the CRT angle adjustment.
Ensure that the rasters are centered on the CRT face.
Press ENTER to start the CRT angle adjustment procedure. A crosshairs (green and red) will be displayed on the screen.
ENTER continues to the crosshairs alignment.
EXIT returns to raster shift adjustment
ADJUST returns to operational mode.
The same projection angle is mis-
aligned for new screen width SW2.
Re-alignment is necessary. Each
screen width change requires re-
adjustment of the projection angle.
Projection angle correctly aligned
for screen width SW1
CRT PROJECTION ANGLE
ADJUSTMENT
CRT PROJECTION ANGLE IS
THE FIRST STEP OF STATIC
CONVERGENCE ADJUSTMENT.
IT IS CRITICAL THAT THE
RASTERS ARE CENTERED ON
THE CRT FACE PLATES
PRIOR TO PERFORMING
THIS STEP....
<ENTER> to read more
<EXIT> to return.
CRT PROJECTION ANGLE
ADJUSTMENT
DURING THIS PROCEDURE, RED
ON GREEN AND THEN BLUE ON
GREEN CROSSHAIRS WILL BE
DISPLAYED TO ALLOW THE RED
AND BLUE CRT'S TO BE ALIGNED
WITH THE GREEN CRT.
LOOSEN BOLTS A AND B TO
PIVOT THE RED CRT AND BOLTS
C AND D TO PIVOT THE BLUE CRT
<ENTER> to continue
<EXIT> to return.