User guide

30 Coronis Fusion 6MP
Key indicator lights
ABOUT THE KEY INDICATOR LIGHTS
By default, after lighting up, the key indicator lights will dim again if no
further actions are taken within the following 5 seconds. However, this
behavior can be changed so that the key indicator lights are always on
or always off.
TO CONFIGURE THE KEY INDICATOR LIGHTS:
1 Bring up the OSD main menu.
2 Navigate to the Configuration > User Interface > Indicator Lights
menu.
3 Enter the Keys submenu.
4 Select Automatic/Always On/Always Off as desired and confirm.
Power lock function
ABOUT THE POWER LOCK FUNCTION
By enabling the power lock function, the CORONIS FUSION 6MP display is
forced to remain switched on. This means that it can’t be switched to
stand-by mode until the power lock function is disabled again.
TO ENABLE/DISABLE THE POWER LOCK FUNCTION:
1 Bring up the OSD main menu.
2 Navigate to the Configuration > User Interface > Controls menu.
3 Enter the Power Lock submenu.
4 Select Enabled/Disabled as desired and confirm.