User Manual

4. CSE-200 Installation
How to install
1. Drill two holes in the wall or ceiling as indicated on the drawing.
Horizontal distance : 162 mm ,
6,5
(2x)
161,84
Image 4-1
Mounting holes
2. Insert a plug in each hole (if needed, depends on the wa ll or ceiling type) and drive in 2 screws. Do not drive in the screws
completely.
Note: Mounting screws and plugs are not included in the CSE-200 box . The type of screws and plugs depend on the type of
wall (stone, wood, plasterboard, ...) y ou are m ounting the Base Unit to. M ake sure the head of the screw is not larg er
than the hole in the bottom plate of the Base Unit (< 6.5 m m).
3. Hook the B ase Unit on both sc rew heads and slide the Base Unit d ownwards un til it is fixed.
4.4 Recommendations about antenna placement and orientation
Antenna placement rules
• The antennas should be oriented vertically, so perpendicular to t he ceiling and parallel to the walls.
• The antennas should be installed far enough (at least 50cm/1.6ft) from metallic surfaces to avoid unwanted reflec tions and
far enough (at leas t 1m/3.3ft) from other radio equipment that operates in the same frequency range, e.g. other Wi-Fi access
points, cordless telephone, microwave ovens, …. It is also best to install antennas at least 15 cm (6 inches) from concrete walls.
• The most favorable s ituation is a direct line
of s ight between antennas and Buttons. Any obstruction will cause the signal to
follow a longer propagation path, which c an result in per formance degradation.
• Due to the particular radio pattern of the dipole antennas, the a ntennas should not be placed jus t above p otential positions of
ClickShare users. As a result, the adv ised position for the antennas is at the side of the m eeting room.
Image 4-2
Closer view of antennas in
stallat ion in the meet ing room
16 R5900023 CLICKSHARE CSE-200 24/05/2017