User Manual

5. Preparing the buttons
Both the LE Ds of the Button and the LEDs of the Base Unit are blinking white. This m eans pairing is in progress.
The Base U nit automatically checks whether the software of the Button is up to d ate. If not, the B ase Unit updates the Button
software. This may take more time.
During the pairing and u pdate process, a small status bar is display.
Image 5-2
Pairing message
The result of the pairing process can be as follows:
- When the LEDs become static white, the Button is paired t o the B ase Unit, but no software update was needed. You can
unplug the Button from the Base Unit.
- When the LEDs become static red, the Button is paired to the Base Unit and the software update has finished. You can unplug
the Button from the Base Unit.
Image 5-3
Pairing finished
2. Unplug the Button from the Base Unit.
The Button is now ready for use.
5.2 P re-install of the Launcher service
Launcher service pre-install
The ClickShare Launcher service can be pre-installed on your laptop or on c ompany level. How this is done depe nds on your IT
infrastructure.
When the L auncher s ervice is pre-installed, a launcher application runs in the background. W hen you plug the Button in your laptop,
the C lickShare application will be run from the Button au tomatically. There is no need to run the file from the Button.
The pre-installer can be downloaded from the B ase Unit’s configurator.
Where to download the launcher installer?
The launcher service (installer) can be downloaded via the technical download section per device from Barco’s website
w
ww.barco.com/clickshare.
5.3 ClickShare launcher installer
Interactive setup
In this setup, user runs the installer an d installs the ClickShare launcher to the computer after accepting E ULA and spe cifying the
installation directory. Follow the instructions on
the displayed s creens.
22
R5900023 CLICKSHARE CSE-200 24/05/2017